DX8 issues with NAZA IOC & Gimbal tilt

[rceeguy]

I have just completed my FW550, and am programming it. I have two issues:
First is I can't get the IOC to recognize my 3 position Flap/Aux1 switch. I have it connected to X2 on the MC, as indicated in the instructions, but it will not move through the 3 modes when I flip the switch. However, I noticed that when in the VIEW summary screen of the NAZA Assistant, the X2 bar moves to 3 different positions when I flip the switch. I have the box checked to activate IOC, but when I move the switch, nothing happens. I have tried Travel & sub-trim on the DX8, but nothing happens.

The other issue is what do I need to do to use my Knob/Dial on the DX8 to adjust tilt on my gimbal. I have what is being called the "eBay China Cheap" gimbal.

 

[Benjamin Kenobi]

It is the travel you need to adjust for the Aux 1 channel. Try again. Make sure the servo setup selects that switch as the control for aux 1. For the gimbal tilt, connect the gimbals tilt channel straight to a free channel on your receiver and again select the correct channel/switch selection. Read the DX8 manual. It's all in there, just takes time to absorb the information.

 

[rceeguy]

I have tried that adjustment.....does not move the pointer. In fact, all 3 modes stay black in color on the IOC page. In switch settings on DX8, Flap:Aux1 is how it is set. Interestingly, when I am in Switch setting on the DX8, I noticed that the 3 modes turn blue in color on the IOC page, but, as soon as I move to the DX8 Main page to make the Travel adjustments, they all turn black again. Very weird. I am all confused. Can't get the failsafe right, it won't calibrate, and when I put the blades on and tried to very slowly lift off, and she leans right. I need some serious assistance.

 

[PeteDee]

From V3.xx firmware you have to do the compass calibration before you can do the IOC setup.

Pete

 

[rceeguy]

My MC is V4. I tried to calibrate but it fails when I turn the craft with the nose down. I tried basic and advanced calibration with no success. I just get the flashing red/yellow led.

 

[Benjamin Kenobi]

Don't put the blades on! Get it working on the assistant first. Learn about the DX8. We all went through this stage. Read and wait for it to sink in.