Droidworx CX4 coax setup

[yakjock]

Has anyone done or seen a CX4 coax as i love the look of the CX4 but the all up weight is not so impressive. If you were to say use the CX 3 two axis mount with a 3d GoPro rig what motor & prop configuration would you use with a 4s 6000 battery, WKM & 40A Maytech ESC's (open to suggestions on the ESC's). Would you be able to do a coax setup with that mount? or would the lower props contact the mount? any advice is most welcome. if this wont work theoretically i will look at a DW hexa setup.

Chris.

 

[nicwilke]

Yes,
I've done it.
http://www.youtube.com/watch?v=Q4wKm6XloOU&feature=plcp

Its fantastic, but you'll need 2x 4s 5000mah or more to get 10mins.

 

[nicwilke]

I'm using 1145 props (carbon fiber) and will swap those up soon with some new Graupner 1150's when the reduction spacers arrive. Yes, the props come close to the landing gear, and I do need to watch the LiPo cables are free from the props slash!!!.

 

[yakjock]

Impressive vid but you have the ADX & i was looking at the CX4 but i guess they are not that dissimilar.

Yes,
I've done it.
http://www.youtube.com/watch?v=Q4wKm6XloOU&feature=plcp

Its fantastic, but you'll need 2x 4s 5000mah or more to get 10mins.

 

[nicwilke]

Ah, OK. Sorry, I misread that. Yes, 2 mates have done that. Fajar from Multirotortech.com.au has one.
http://www.youtube.com/watch?v=vlqdOtiRgg4&feature=player_embedded on board footage.

 

[yakjock]

It looks like it can handel the wind well! but there is a lot of motor & prop in the shot that's something for me to think about.

Ah, OK. Sorry, I misread that. Yes, 2 mates have done that. Fajar from Multirotortech.com.au has one.
http://www.youtube.com/watch?v=vlqdOtiRgg4&feature=player_embedded on board footage.

 

[nicwilke]

It looks like it can handel the wind well! but there is a lot of motor & prop in the shot that's something for me to think about.

Yes, that is something to consider. Good luck