BrundleFly
Member
This may be idiocy on my part, but I would like a learned opinion from a kind veteran, if I may.
Got the Droidworx AD-3 Standard Lift frame and AXI 2217-20 motors, SimonK-flashed DYS 30A ESCs and plan to run it on one or two 4000mAh Turnigy Nanotechs, 4s, 25-50c. The last part is the only difference to the data entered below, the nearest option being "35/50c". Will hang an AV130 off it with a 200g point and shoot. AUW should wind up at 2.2kgs, max. Importantly, I was going with the recommended 11" Graupner props. These specs give me this:
(DISCLAIMER: I know it's not a hexa and that this calculation doesn't take into account the potentially lower power the co-axial config might imbue.)
View attachment 6719
Surely this can't be so. Yet it likes 10" props....
View attachment 6720
Am I doing something wrong, here? I don't wanna blow any(more) of this expensive higher-end equipment I find my evil other buying these days. I'm sure I must be missing something very simple, is all. The blurbs say 10 or 11 inch Graupners. WaddaIknow?
Cheers
Got the Droidworx AD-3 Standard Lift frame and AXI 2217-20 motors, SimonK-flashed DYS 30A ESCs and plan to run it on one or two 4000mAh Turnigy Nanotechs, 4s, 25-50c. The last part is the only difference to the data entered below, the nearest option being "35/50c". Will hang an AV130 off it with a 200g point and shoot. AUW should wind up at 2.2kgs, max. Importantly, I was going with the recommended 11" Graupner props. These specs give me this:
(DISCLAIMER: I know it's not a hexa and that this calculation doesn't take into account the potentially lower power the co-axial config might imbue.)
View attachment 6719
Surely this can't be so. Yet it likes 10" props....
View attachment 6720
Am I doing something wrong, here? I don't wanna blow any(more) of this expensive higher-end equipment I find my evil other buying these days. I'm sure I must be missing something very simple, is all. The blurbs say 10 or 11 inch Graupners. WaddaIknow?
Cheers