DJI NAza m V2 - Problem with my Naza need help

D

derrickcheang

New Member
HI there,
I'm new to using these devices and am facing a problem now and I'm stuck.
I have a DJI with Naza m V2.
Recently I tried to upgrade the firmware from 4.00 - 4.02 latest version.

While doing so, installed the Naza assistant software on my Win 7 PC and the driver as well.
When plug into the USB cable to Naza, everything was fine and the software recognised the Naza device.

I was then prompted to upgrade the firmware and I said ok.
The next prompt was to ask me to disconnect all motors other devices.
At this point I was not sure about what to do, thus I decided to wait for a friend who did it before before I take any risks.

Thus I went to turn off the power of my craft.

The device was than disconnected from my PC.

But however, after this point, when I tried to turn back my Naza back on, the device started to make a loud beeping noise.
The Naza also does not have any LED light at the bottom.
The beeping noise initially was just 1 at a time, but start increasing to multiple after about 20s.

THe NAza looks dead now everytime I turn it on and the beeping sound just continues.

I'm stuck now cause nothing works.
THe whole craft just cannot 'boot up'

Is there any advice that anyone can give ?
Or is there such a thing as hard reset Naza

Any help will be appreciated

Thank you Thank you
 


D

derrickcheang

New Member
Hey dude,
Thks for your reply.
I tried,
But issue now is this problem is happening and the Naza is like its 'dead'
Meaning plugging into the PC cannot even detect the USB device.

It sounds like when we used to assemble our own PCs and some RAM or device is not plugged in, and the bios starts beeping.
But I checked all cable connections, they all look fine.


rilot said:
Have you tried connecting it to your PC and doing the firmware upgrade again?
Click to expand...
 

T

TheUFGadget

Member
Can you please post a video of the naza booting up? Once we can hear the sequence we can help determine a problem :). If the beeping has changed it sounds more like an ESC issue than a Naza issue.
 

coreyperez

coreyperez

Member
It sounds to me like you interrupted the flashing of the Naza. Hopefully you didn't "Brick It". I'd recommend rebooting the computer, possibly uninstalling the driver and reinstalling. Ensure the power is off on the MR and then re-power it up. The only time I've experienced this is when the PMU is unplugged (where the GPS plugs into). Once I re-plug that in, the beeping stops on my F550. BUT... I've never interrupted a flashing process on the FC.

Corey
 

Benjamin Kenobi

Benjamin Kenobi

Easy? You call that easy?
I would say just keep trying. It will work eventually. Did you close/cancel the upgrade screen before you unplugged the NAZA?
 

B

blade strike

Member
You bricked the controller. connect "F1" and "F2" port with a 3-pin servo cable, then do the firmware upgrade again to restore it.
 


You must log in or register to reply here.
Top