Hi Magoebaskloof
I'm relatively new & found it difficult to set up my 18MZ as there are very few videos that show this particular Tx.
Firstly the NAZA M setup is best shown on the DJI website where they show these hardware connections in detail. I'm not sure if S Bus works with the V2, much discussion going on about this. I have connected each Rx channel to the NAZA as per DJI video. Set the Tx model type to airplane & you can set your own Quad name in "Model Select". I've selected FASSTEst 12CH setting in System Type. In Function menu _ CH 1 -Aileron - J1/ Ch 2- Elevator J2/ Ch 3 -Throttle J3/ Ch 4 - Rudder J4/ CH 5 DJI Mode (Set to SE switch) / CH 6 Gains (Set to LD knob) / CH 7 - IOC (Set to Switch C). Not sure about Gimbal/camera _
someone else can chime in here.
As far as set up of channels on the Futaba this is where I really struggled for help until I watched the DesJardin videos which show how to set up Failsafe & switch mixing on a different Futaba model but I worked out the 18MZ equivalents. REFER to
attached list of videos I have found of use.
I'm an absolute newbie to RC setup but my quad seems to fly quite well so far in all modes even though I don't fully understand the theory of the Tx setups. I guess a lot depends upon the hardware you have for your copter, & in my case I bought mine from MultiWiiCopter.com who have a step by step Noob guide to building their Scarab Armour which is what I have. Let me know if you need more help.:apathy:
View attachment 12351