Only place that list's them as in stock is one in The Netherlands but also demands 70 euro shipping which is a farce. Everyone else is in pre order phase.
In my mind the iOSD is needed for people using the data link and Zenmuse for use as a hub.
no software that i am aware of.
the new firmware has indeed a roll indicator on the OSD.
and not as seen on the video.
thats all know also
dji had a weeks holiday , and needs to get back online.
yes we know
we are trying desparatly to get a new webshop
this one is to outdated we got new contracts with couriers , trouble is we have to type all by hand.
and with about 30 orders a day its a immposible task.
with ups i can make the order ready in 20 seconds incl label.
if i use TNT it takes me 12 minutes for each order so impossbile task for now.
I cant get a picture on the osd only the osd data ? What an I doing wrong?
I can get a picture from the Z15 but not from my FPV Camera.
Am i the only one having problems?
Hi Sandor
I tried to connect to AV1 and AV2
I use a immersonrc 600mv tx.
I tried with seperate supply to the TX and from the OSD.
the output from the OSD i messured to 24V but I have the version 2 TX so that should be OK.
And I cant get it to swich between ch1 and ch2 and it only show ch 1 in the display.
I can see on RCG that others are having problems too.
i have left the power from the Zenmuse to power the TX
i have grounded both av1 - and av out - together to the TX ground
i cut the yellow wire to the TX and put them between the AV in and AV out.
worked on all occasions
i did NOT use any other cable or not even the switch to toggle between AV1 and AV2
can you check this?
we use also Immersion 600mw.
i DO have some issues comming from TX units that dont work these last weeks.
and never seen this before
I got my iOSD from www.buildyourowndrone.co.uk about a week ago, I know they do same day shipping to the USA and Canada with FedEx, so you could have one in a few working days. I really enjoy the FPV on my Wookong! I have seen it used on an S800 spreading Wings last weekend, that is a set up!
I just got my iOSD and 5.8ghz tx/rx yesterday and will be setting it up this weekend. It would be nice to know where others have mounted theirs. I'd like to keep it on one of the plates but it almost makes more sense to put it on the bipod. I also received my GPS/Compass 10 days after shipping it out. Time to get busy!