DJI iOSD not working :(

M

modles

Nerdlinger
Hello

Right this is my second issue with my wookong setup.

I had everything working, iOSD was outputting data and video (from 5v camera on separate supply) fine, great I thought, all done! Then without any hardware or software change, just a battery pack unplug, plugin, the iOSD seems dead. The red power light is on, but no output coming from the video out.

I have this running through the dji 5.8ghz system, and that was working fine. To test where the problem might be, i hooked a screen directly up to the output of the iOSD and nothing, not output at all. I have checked all can-bus links, all seem fine. So odd that it was working great for about 5 mins and then now nothing.

Any ideas to try or does it look like i have a brick?

Cheers

Ben
 

VINHEX

VINHEX

Member
Could be on cam2 rather than cam1 default I had this happen. Check switch which controls camera or plug lead into camera two. Hope this works
 

M

modles

Nerdlinger
Thanks for the reply. Now Im thinking even if it switched over to channel two I should still get iOSD data coming through on the feed no?

Or does cam 2 feed not have the overlay?

It doesn't say anything about this in the manual.
 


You must log in or register to reply here.
Top