Hello,
I am a newbie in RC multi rotor. Looking for help .
I just finished building my first DJI F550 . after take off it keeps spinning and very unstable . I build it twice (after got damaged first time) and found same problem. After initial take off it keeps spinning .
here is the youtube video link for that
take off mode was GPS
I have used
DJI NAZA M lite (firmware upgraded to Naza V2 ) with GPS
Simonk ESC 30A
2212 920kv brushless motor
Flysky FS-R9B 2.4G 8-ch Receiver
FS Flysky 2.4G 9ch Transmitter Radio Control FS-TH9X
4S Lipo 5000mah
props 9.4 inch self tightening carbon fibre (not 100% balanced)
ESC calibration was done for all of them. GPR calibration was done. I have double checked the rotation of the props Odd motors are CCW even motors are CW
NAZA setup screenshot is also attached.
Appreciate if you have any suggestion if you know know how to fix this
I am a newbie in RC multi rotor. Looking for help .
I just finished building my first DJI F550 . after take off it keeps spinning and very unstable . I build it twice (after got damaged first time) and found same problem. After initial take off it keeps spinning .
here is the youtube video link for that
take off mode was GPS
I have used
DJI NAZA M lite (firmware upgraded to Naza V2 ) with GPS
Simonk ESC 30A
2212 920kv brushless motor
Flysky FS-R9B 2.4G 8-ch Receiver
FS Flysky 2.4G 9ch Transmitter Radio Control FS-TH9X
4S Lipo 5000mah
props 9.4 inch self tightening carbon fibre (not 100% balanced)
ESC calibration was done for all of them. GPR calibration was done. I have double checked the rotation of the props Odd motors are CCW even motors are CW
NAZA setup screenshot is also attached.
Appreciate if you have any suggestion if you know know how to fix this