DJI F450 build

[skipper1]

Everything seems to be going in the right direction for my DJI F450 build. I have a couple of questions.

1. The V-SEN unit. Where are the red & black leads supposed to be soldered, any particular place?
2. On the V-SEN, is the 3 pin cable supposed to be plugged into Aux 3 on my AR8000 or some place else? I really don't have a clue.
3. Is the NAZA Master Control supposed to be anchored down using the double sided 3M pads? I've read the need a bit of a cushion but these don't look like they'll give much of a cushion.
4. I've read that the battery strap that comes with the F450 isn't very good. Is there a particular battery strap that will work better and if so, which one?

Just an observation, don't ya think the legs could have been just a few more inches taller?

I hope to have it in the air this weekend so any help you can pass along will be appreciated.
Skip

 

[Elliott000]

http://www.dji-innovations.com/files/naza/NAZA_User_Manual_en.pdf

page 7 will answer your questions about what wire goes where, i soldered the V-Sens leads tip the same pads as my battery leads, my naza is 3m taped to the center of bottom frame... no foam just the double sided syuff but its not the stuff they supplied its some other 3m i have, and I use an align starp af one of my helicopters plus a patch of opposite velcro on the frame plate!
Keep at it man
Elliott

 

[skipper1]

No wonder things didn't make much sense. I downloaded the manual a few weeks ago and page 7 is missing. I downloaded again and NOW I understand much better.

Elliott, thanks for your help. I hope the software goes smoothly.