DJI f330

[kloner]

Been gathering parts for a while to build an f330. was trying to use a Free Flight controller, but after smoking one the first 10 seconds i touched it, decided to go back to what i know. if nothing else, got parts to always keep one in the sky no matter what now. the only thing left is mounting a Fatshark ccd killer cam, 5.8 vtx. The turnigy rx is a bit of a trial. it has dsm2 and s.bus and dual sat inputs. sure made a clean install. trimmed all the esc leads to length and re did the end as well as wrapped em in shrink wrap to keep them protected.

Parts:
f330 frame
dji 2215 motors
rctimer 18 amp esc's
turnigy 9x
fat shark ccd killer
fat shark 100mw vtx
cloverleaf
graup 9x5

waiting on a storm to push out of here to shake it down, but that vid was the first attempt at hopping up, if that's any indication, i'm there............