I'm not sure if this is the best way to reach out on this forum but I'm not getting any response to my emails on that subject.
I design and manufacture various accessories for DJI products: Landing gear, Camera mounting plates that use silicone gel bushings to reduce vibration, and battery mounting plates.
Many of my products are cut from carbon fiber for maximum strength and lightest weight. The camera mounting plates allow not just my camera mounts to be attached, but ones from Photohigher and Mikrokopter as well. I also make products that permit attachment of the Zenmuse Z15 to a Droidworx frame.
You can inquire about these from your favorite dealer or purchase direct from me at www.multirotorsolutions.com
Again, if this is not the proper method to inform you about this then I apologize and I will gladly set things right.
Thanks,
Mark Dana
Precision Digital Imaging
Multirotor Solutions
I design and manufacture various accessories for DJI products: Landing gear, Camera mounting plates that use silicone gel bushings to reduce vibration, and battery mounting plates.
Many of my products are cut from carbon fiber for maximum strength and lightest weight. The camera mounting plates allow not just my camera mounts to be attached, but ones from Photohigher and Mikrokopter as well. I also make products that permit attachment of the Zenmuse Z15 to a Droidworx frame.
You can inquire about these from your favorite dealer or purchase direct from me at www.multirotorsolutions.com
Again, if this is not the proper method to inform you about this then I apologize and I will gladly set things right.
Thanks,
Mark Dana
Precision Digital Imaging
Multirotor Solutions