Can't enter the compass calibration

G

gweleps

Member
Hello,
I've just install a WKM with 5.24; i just can't enter the compass calibration process. The GPS control switch works fine as per the assistant software display but when i flipp the switch to enter the compass cal process i never get a blue light...
The LED is always blinking green/yellow which means "abnormal compass data"... I was assuming that it was because the compass was not calibrated.
Any advice?
Thanks
Alain
 


G

gweleps

Member
Yes; I can verify it with assistant software. Each position of the switch make the corresponding area blue and it swtiches between MANUAL, ATTI and GPS
Alain
 


G

gweleps

Member
thanks all, it's working now .. I think i didn't flip the switch fast enough yesterday (and i didn't stop the sequence after 7 or 8 flips..)
Alain
 

You must log in or register to reply here.
Top