Droider
Drone Enthusiast
After failing on my first attempt to build a error free Hexa XL board I am about to statrt a new one.
Can some one tell me the exact resistances to be expected between + & - on a hexa xl distribution board when it is fully built up with 6 BL2's
Also the resistances between C & D and + & -
Is there a wiki anywhere other than the hexa xl build wiki.
Can the Distribution board be tested for 12c errors as it is built..
Stage one
solder molex on board.
Stage 2
Test board for 12c continuity then check in MKtolls that there is no 12 error
Stage 3
Fit first BL test for shorts and continued continuity through 12c circuits, check in MKtool for error free 12c and recognition of first BL
Anyone??
Dave
I thought I was super super precise taking my time with the last build but I think there was a fault with the board.. below build pictures
Can some one tell me the exact resistances to be expected between + & - on a hexa xl distribution board when it is fully built up with 6 BL2's
Also the resistances between C & D and + & -
Is there a wiki anywhere other than the hexa xl build wiki.
Can the Distribution board be tested for 12c errors as it is built..
Stage one
solder molex on board.
Stage 2
Test board for 12c continuity then check in MKtolls that there is no 12 error
Stage 3
Fit first BL test for shorts and continued continuity through 12c circuits, check in MKtool for error free 12c and recognition of first BL
Anyone??
Dave
I thought I was super super precise taking my time with the last build but I think there was a fault with the board.. below build pictures