Beholder Brushless Gimbal for DJI FlameWheel 450 and GoPro?

E

eturn23

Member
I just ordered a Beholder Brushless Gimbal for my DJI FlameWheel 450 from CNChelicopter.com. I was wondering if anyone has any experience using this gimbal? The instruction manual says to use 2S or 3S batteries, but since I just installed some RCTiger 2814-10 (770 kv) motors on my FW450 I was going to switch to 4S batteries. Does anyone know if 4S batteries will damage the gimbal? Should I stick with the 3S batteries I am using now? Thanks for any info you can provide.


Here is my setup:

DJI FlameWheel 450
RC Tiger 2814-10 motors (770 kv)
DJI Opto 30A ESC
Naza V1 with V2 firmware installed
APS 10 x 4.7 props
Spektrum DX8 radio
Spektrum AR8000 receiver
Sky Lipo 4400 mAh / 11.1v / 3S / 40C batteries


no GPS and no FPV, but will be adding these soon
 

T

tstrike

pendejo grande
It looks like a version of the martinez open source board, I run mine off the 4s flight pack no problem. Some guys are using regulators to give a consistent 12 volts to the gimbal even while the main batt drains.
 

I

Idahobell

Banned
Don't get the Beholder GoPro Brushless Gimbal RTG. I tried that with my Naza-M and Futaba 8FGS and it didn't work. It comes with a split wire for the tilt control and it does not work with the Naza-M F1 and F2 ports.
 


You must log in or register to reply here.
Top