AP Heavy Lift Octo with 3 Axis Cinistar Clone

Tdeman

New Member
Hey guys, I just recently built and setup this AP Octocopter, but am realizing it might be a little more bird then I need
rolleyes.gif
Anyways, sorta seeing if there would be interest in this setup, here's what it consists of...

-QuadframeUS 850mm Alu Boom Octocopter frame

-Arduflyer 2.5 with case, NEO 6m GPS, and 915mHz telemetry/3dr's

-RCtimer CM-301 Cinistar Clone Gimbal (pitch and role stabilized by independent mwc mini)

-Ipower 2814-q 750KV motors with HQ bearings

-Hobbyking F30A SIMON K esc's

-GemFan 12x4.5 Carbon Nylon Props

-(2x)Turnigy 6000mAh 4s Lipo's (2 cycles) (In Parallel give about 8 minutes flight with T2i)

-Green and red LED's on 3 of the booms.

Anyways, solid setup that flies great and will handle a DSLR w/fpv gear no problem. Hovers around 50%, and flies for around 8 minutes. Haven't tinkered much with the APM GPS functions/3drs yet, since I just got it setup and flying, but this thing is ready to go to work in the professional AP field. Like I said, not totally sure I'm selling it, but should the right offer come along it's yours! I can upload more recent pictures with the clear dome and a few other slight cosmetic changes, if you guys would like to see them.

Looking for around $1500 OBO shipped and insured.
 

Attachments

  • Octo done.jpg
    Octo done.jpg
    157.4 KB · Views: 526
  • photo (2).jpg
    photo (2).jpg
    141.6 KB · Views: 322


Top