Mike Fortin
Member
AlexMos Yaw Programming Snafu - Thoughts?
Hi Guys,
Hoping I can get some feedback on the AlexMos, I spent today getting this gimbal built and setup and so far I have pitch and roll pretty darn good.
However, Yaw will not cooperate. Using the DX8 for control, when any movement is given to yaw we get a bit of "windshield wiper" action and then the gimbal settles in about 60-70 degrees off center to the right but will barely if at all react to any inputs coming from the DX8.
I've also done the 6 axis calibration.
Pitch/ Roll is responding perfectly.
Any ideas, thoughts or setups you can share is greatly appreciated.
Thank you.
Are there any very good tutorials on setup of this board?
Hi Guys,
Hoping I can get some feedback on the AlexMos, I spent today getting this gimbal built and setup and so far I have pitch and roll pretty darn good.
However, Yaw will not cooperate. Using the DX8 for control, when any movement is given to yaw we get a bit of "windshield wiper" action and then the gimbal settles in about 60-70 degrees off center to the right but will barely if at all react to any inputs coming from the DX8.
I've also done the 6 axis calibration.
Pitch/ Roll is responding perfectly.
Any ideas, thoughts or setups you can share is greatly appreciated.
Thank you.
Are there any very good tutorials on setup of this board?
Last edited by a moderator:
