DesJardins
Member
I'm going to make a video tomorrow to get all the functions set using channels assigned to the top left 3 position switch for (Manual/Alt/GPS) the 2 position switch behind that one on the top left for forced Failsafe & the middle knob for Gain control.
Also setting (loss of signal/8FG turn off) failsafe with the end point and minimum 10% throttle "per Naza instructions"
The one problem I'm getting, which I don't know if it's an actual worry, is that I can get all the failsafes to show in the designated failsafe boxes in the Assistant software EXCEPT for one. Either the manual/failsafe or GPS/failsafe depending on my mixing if I go negative or positive in my Aux6-Aux5 mix for the 2 toggle switches.
one of the failsafes goes off the screen (still says failsafe) but being outside the actual failsafe indicators really bothers me since I'm a stickler!
(video posted below)
Also setting (loss of signal/8FG turn off) failsafe with the end point and minimum 10% throttle "per Naza instructions"
The one problem I'm getting, which I don't know if it's an actual worry, is that I can get all the failsafes to show in the designated failsafe boxes in the Assistant software EXCEPT for one. Either the manual/failsafe or GPS/failsafe depending on my mixing if I go negative or positive in my Aux6-Aux5 mix for the 2 toggle switches.
one of the failsafes goes off the screen (still says failsafe) but being outside the actual failsafe indicators really bothers me since I'm a stickler!
(video posted below)
Last edited by a moderator: