Gary Seven
Rocketman
Hello folks.
While picking up the usual odds and ends from HK a few weeks ago, I decided to buy their parallel adapter with XT60 connectors for the F550 build I'm working on. This build will utilize the DJI E310 system and I plan on using two 4000 mAh batteries in parallel. Anyway, to my concern my stuff arrived and I immediately noticed that the parallel adapter I ordered was built using 16 AWG wire. Does this seem way "underspec" to anyone else?
Here are the specs on the E310 system: http://www.dji.com/product/e310/spec
As per usual DJI's numbers are sparse and far and few between, but if I build a hexacopter with six ESC's rated at 20A plus the six motors, my gut feeling is the 16AWG adapter is NOT going to handle that. Seems to me the wire gauge should be around 12 AWG. Could someone please advise? Thanks!
While picking up the usual odds and ends from HK a few weeks ago, I decided to buy their parallel adapter with XT60 connectors for the F550 build I'm working on. This build will utilize the DJI E310 system and I plan on using two 4000 mAh batteries in parallel. Anyway, to my concern my stuff arrived and I immediately noticed that the parallel adapter I ordered was built using 16 AWG wire. Does this seem way "underspec" to anyone else?
Here are the specs on the E310 system: http://www.dji.com/product/e310/spec
As per usual DJI's numbers are sparse and far and few between, but if I build a hexacopter with six ESC's rated at 20A plus the six motors, my gut feeling is the 16AWG adapter is NOT going to handle that. Seems to me the wire gauge should be around 12 AWG. Could someone please advise? Thanks!