Search results

Hallo all I've gone with the idea of ​​building a Hexacopter and I have come to this one compilation of parts. What do you say about that? Would it be the right parts or do you have suggestions for some changes. I'm sure one could spend much more money, but since I am a beginner and do not have...

They did not answer me, so I plan to send it back tomorrow. It was a shame, I'll never know what is wrong with it. I'm actually a little surprised they did not answer me. In fact I have already written to them 5 days ago, but used their error reporting system on the page, but this request was...

I have just written to the European branch of the DJI, so now I hope they know something more than we do. I will return when I've got answers. Crossing my fingers :dejection:

I face a dilemma there because I only have 10 days before the seller gets his money and in that time he must either get it back or I need to find a solution. I would much rather buy a new VU, but since there are no dealers in Denmark it will take more than 10 days to get. So I think now that I'm...

Yes, it would be so easy if it were so, but I have tried many different cables, and none work.

It does this, but I've tried to connect without receiver, and it is the same.

I will test it as soon as I get home, but I have not seen that there should be an additional LED

yes, there are not many flying with that type of aircraft in Denmark. It would be much better to just try and change the different parts and see when it works. That can get expensive without borrowing one that works.

I have installed the correct driver, and the same for all the PCs I've tested

I just put a USB key to the USB drive. There is no problem to open it. I also tried not to have the receiver on my Naza, but it does not make any difference.

Here is my setup of my unit. LED is connected to X3 and LED. It turns orange after three times flashing green. No response to the PC connection, either before or after the green flashes.

Yes, I know that there must be an Unknown device if everything work properly, the problem is just that there is no response from the PC. It seems as if it is completely dead on the USB side. Have tried many different USB ports and cables. Neither an Unknown device or a Naza. The picture...

You can connect Naza without plugging anything else in your controller. See if you can get connected to the PC just like that

It was the very first thing I tried, but the computer can not even recognize an unknown device when I put it into the USB port. There is nothing that pops up in device manager. I also tried to install and uninstall the drivers and numerous USB ports. And all this on two different PCs - Win7...

This is my first post, I will start out by saying that I am impressed with the forum. I've been through all pages on Google dealing with the issue and there was nothing that could help. Most problems refarer to diver problems, but I'm almost sure it is not my problem.But here's my problem that...