Search results

Hi drhswe I found your thread while browsing and find very good idea on the ikea reda container, Thanks a lot buddy. I will get one soon!!! Wonder is the frosted container block any gps signal? George

Hi Dave, Thanks for reply. My current setup is opt0 30A with APC13x6.5 prop, I suppose if reduce the prop size and upgrade the ESC to 40A will lower the temperature right? Wonder what prop you use? George

Hi Droider , My opto 30 is getting 65 Celsius after flight(dw y6, not install gimbal yet) , I am not comfortable with this. Wonder what's ur setup is?

Hello I just build my DW Y6, maiden without any yaw problem.The only issue is a bit wobble while take off compare to mk, I have already key in the exact location of IMU and GPS in dji assistant sw but only improve a bit, could it be the default gain is too high? Few question here: 1. What is...

Hi, I own 2 Mk and fine this is the time for me to try out WKM on Y6, anyway I have few question below: My setup is DW Y7 Axi 2814/22 motor photohigher av130 mount Plan to carry nex5n or occasionally a canon t2i 1. What esc should I use? the dji opto 30A is enough for me? 2. Is there any good...

I keep figuring should I switch to WKM with current promotion on 5 waypoint datalink package. I have a monthly assignment, I wonder will WKM really that less hassle if compare to MK? I am building heavylift Y6 with the MK hexa XL and BL on my desk now......

Bartman, I alway have fear to look at mk expose electronic day to day, I know there are many happy mk flyer out there but this incident really make me rethink about should I change my controller. I consider myself a careful flyer, I own 2 MK and happy that I have never crash them before. may I...

Hi Andy,apreciate your advice, oh, now I know what is the transistor,I do have the extension PCB which I never solder it out as it too tiny soldering work for my skill. A close examine show that the hole where spark shoot out is the passage of a circuit line bury under the pcd coating...

Andy, what do you mean by LED transistor? For my case, any advice what should I do next? I guess the PBD need to be dump and rebuilt the PBD ring with the BL again right?

I have check the underside of the pdb and Bl and find no burn mark or anything. As you can see the smoke stain on BL is cause by flame shoot from a small hole from pbd Yes. I had remove the dome often to connect mktool or doing soldering job for extra LED and bec and other task

Hi everyone, This is a first incident happen to my MK OKTO XL after 6 month happy flying. Few days ago when I bring down my okto to site for a job, upon lipo plug in, there a smoke emit from the some electronic underneath the dome. After checking and bold enough to retest with lipo plug in, I...

Thanks plingbot, I may consider wookong on my next built. You should be very happy w mkm now? May I know for Mk, is ur mkm file for y6 in this thread is good or u hav a better version that I can download ? And for the left arm facing up / down motor , should it solder to BL 1 and 2 ? Should all...

Plingbot, sorry for your crash. Is your crash happen to Y6 only as isolated case or it also happen to your other mk? What is the major advantage of MKM over MK on your experience?

Hi Plingboot, Is a joy to found your thread on Y6 which what I am doing now, Since you thread is almost a year now, may I know how is your Y6 perform compare to hexa2? Or did you convert it back to hexa again? I am looking for the Y6 mkm file now, can you send me yours? What motor...