Search results

Hi All, Does anyone have the A2 with 2.3 firmware fully working with the IOSD Mini? - Yes I know the mini is not listed against the A2 on the DJI website, but it is in the compatibility chart on p42 of the A2 manual and it did work previously:- With previous versions it worked fine, but only...

Anyone interested in buying my Piclox 3X v1 with latest firmware in it? - Time to move on to other things..... Malcolm

I had the same problem when I updated my V1 Picloc 3X to v58 firmware. You could see the gyro sensor tab continuously increasing, even after several calibrations. (The calibration would zero it - then the reading would start to drift).The Pan gyro null adjust was centred, but even when changing...

Thanks Eric, will look forward to your feedback on the JR servos. Hitec quote a deadband of 2uS, but I don't know if that translates to step resolution. I do know that they appear to be super smooth in manual control, especially with the 6:1 reduction gear I have now, and I can't see any shake...

OK - happy to try new firmware when you have got it ready - this thing is not going to beat me! Cheers, Malcolm

Hi George, Have done that and it seems pretty good. gyros are zero, X/ Y accel are showing zero to -3 and Z is 265-268. Artificial horizon is steady as I slowly rotate the Picloc. - Any other ideas? Cheers, Malcolm

Alex's issues seem to be exactly the same as I have been struggling with over the last week. My mount is an AV200 style, with 360 deg pan, and roll and tilt using feedback pots. I can get it to stabilise nicely on the ground -using a spirit level to make sure it is staying centred in roll and...

:nevreness:Thanks to George for taking the time to support me on Skype. After a bit of investigation found we needed to revert the outputs to the default S1 Tilt, S2 Roll, S3 Pan to get it to behave correctly. Something not quite linking up properly when I had it set to S1 for pan... but happy...

Hoping that it can be sorted out - Malcolm

Hi George, Yes pan is set as 360 servo No - I am using S1 as pan (S1 pan, S2 roll, S3 tilt) - I think I moved these around while working out that the tilt and roll controls are transposed. Here are my current screens - but as you can tell from my earlier posts, I have of course also...

OK - have been back through the pan set up again and still can not get it working correctly. All tests below carried out with mount hanging from pan gear - ie as it would be in flight. Servo centering set to give no movement at 0uS. In non slew mode it turns to its start position and...

Ok -thanks. Must be something I am doing wrong. I'll check the centre position in software again and work my way through the pan set up once again! Malcolm

Hi Knilch, Thanks for the reply. Which stabilised mode are you using? - slew or non slew? I just moved the existing pot out of the servo and fixed its position. I can get it rock steady connected direct to a receiver, pretty good if trimmed in the menus with no RC connected or connected in...

Hi Guys, I could do with some help on setting up my Picloc 3X Std. I have had it since they first came out, but to be honest, gave up on it after many fruitless hours spent struggling with hardware (poor solder joints) and firmware bugs in the earlier versions. After seeing what looked like...