Search results

I'm not sure but can you get an opto esc with BEC? My understanding is that the opto does not transmit power to the receiver and an it would therefore require its own power source, so a BEC integrated into an opto esc would be redundant? The platinum esc that I have used does provide power to...

This is the one that I use. http://www.hobbywing.com/product_show.asp?id=194 Jason

The 40a platinum pro (blue colour) that I use have a BEC installed. For the hoverfly pro I have removed all of the red wires except one to the board. I haven't cut them but have taken them out of the servo plug and heat shrinked them in case I ever need them again!

I use the one with BEC and it works fine. No compatibility issues and they arm fine.

I'm having real trouble getting my AV130 360 pan to settle. I've stopped it from spinning by adjusting the sub trim, but every time I power back on it starts to spin and needs re-trimming. Is this usual or should it be consistent once it has been set?

So if I have only just bought the kit, should I get the extended shaft for free, as there is no way the current shaft can fit as outlined in the instructions.

Glad you got an answer! Good luck with the build.

It's probably worth contacting 1001copters as their site shows a 550d on the av130. The issue seems to be the video out which requires an angled cable as there isn't enough room for the normal straight cable which, was the discussion on the forum.

I think somebody has posted about the ability to fit the 550d and the issue with any output cables. I think it was in the on going post about the rsgs problems. I'm only looking to run a gopro or a Nikon v1.

I've been advised that I should be able to put all of the spacers and be able to tighten the bolt. I'm away from home at the moment but will send them a photo as they have requested. The tray is a strengthening tray that you can put in if you want to but for me us impossible due to the short...

Glad it's not just me! Did you put any washers (even your own) on top of the av130 as it catches the servo screw without the black nylon washer.

Can anybody offer any advice on assembling the above. I've followed their instructions but it seems as though either the pan shaft is too short or the spacers are too wide. No matter which combination of parts I use the droidworx tray either rubs on the av130 or there is no room to get the...