Search results

i am getting a flashing red light along with a solid green light when i plug my computer into the naze, i can calibrate the magnetometer and acelatrometer and can see that they work in cleanflight, just don't know what i did to get that red flashing light, any ideas, thanks

i am setting up 3 way and override switches, I've got the" SE "switch set for the modes, I can get the offsets for atti and gps to land on the right spots, but for manual, i can get manual highlighted on the assistant but when I hit enter on the radio the highlight slides over to the right side...

when setting up my mode switch,and while in the assistant, when moving the blue indicator from gps to atti to manual, i could not get that blue indicator to hit the manual button, i can see it over on the far right side of the screen, but can't get it to land on the manual button, when i test...

picked up a f550 kit from hobby king awhile back, have been putting it together slowly over the last couple of months, in the instructions it it states that 10" props could be used on this frame, so when i ordered all the parts I ordered 10" props, when I installed the props I found that there...

i ve got my copter put together and now setting up the naza . but how have you guys calculate the vertical cg. Do i need to rig something to hang it off of to get the balance point? I am thinking the cg is somewhere in between the top of the batteries and the bottom frame plate. Am i going in...

just received all the parts for a thunder s550 , started to put the frame together, now i am the point of calibrating the throttle limits on the esc's, but now I have a question . I am using afro 30 amp esc's that are supposed to have simonK firmware in them, the question is, after the throttle...

just wanted to know how to connect power leads from a naza mv2 pmu board to the intergrsated board of a thunder S550, I was planing on sharing the + and - terminals of one of the esc connections, or is there a better way ?

hi to everyone in the forum, My name is bill from kamloops BC, i have just ordered parts for a first build, its going to be a S550 hex copter, going to run quanum mt 2814 at880 kv with afro 30 amp esc's and a dji naza mv2 controller gps combo also bought a Frsky Taranis x9d plus radio order it...