Search results

  1. W

    DJI NAZA and DX8.... Do I really want to program fail safe in the DX8?

    Will the Naza go to failsafe if the Rx fails?
  2. W

    Failsafe with Hitec Aurora?

    Throttle above 10% but less than 50%. Switch in "Failsafe". Rest of positions not important.
  3. W

    14 Stiches later, I think something is wrong with my DJI 450 Naza...

    When you are using trim to set ATTI and MANUAL make sure you go right through the blue box and count the number of clicks while the box is blue. To find the range/length of the blue box in clicks then set so is middle of this range. I notice on mine that the blue does not light up untill i am...
  4. W

    14 Stiches later, I think something is wrong with my DJI 450 Naza...

    It does not matter what the value is as long it is above the 10% cutoff value and less than 50%. When in failsafe the Naza takes over control of the throttle so that Tx throttle position has no effect. Thinking about it, may be this is what happened to you. Naza went to failsafe and ramped up...
  5. W

    14 Stiches later, I think something is wrong with my DJI 450 Naza...

    1.Turn off throttle alarm on Tx. 2.Setup Failsafe. 3.Reset throttle alarm.
  6. W

    Red flashing light

    GPS satellites < 5 Is this with copter inside or outside?
  7. W

    UPDATE : Toilet bowl in NZ after Firmware 5.06 release

    Can you try turning the Gps/compass module about 20 deg to the right, point the arrow to the right. I am interested to see if this makes the effect better or worse. Should only take a few seconds to give the unit a quick turn then test fly.
  8. W

    DJI motor spinner screw replacement?

    Has anyone tried drilling a hole in the propnut and locking with a piece of soft wire? Through the hole and around the prop.
  9. W

    Simple test BEFORE flying for the first time, NAZA F450

    Simple test procedure before flying a new copter for the first time. On frame near motors mark rotation , felt tip pen or whatever, using instructions for correct rotation. Run motors WITHOUT props, at low speed, touch each motor with the end of your finger to find direction. Shut down...
  10. W

    don't use DJI props they snap 8"

    Is it possible that the nut is tightened too much? It is my understanding that it is the "Flats" that prevent the prop from rotating on the motor shaft. The nut is only to keep the prop on the shaft, there is not much surface area for the prop to lock onto, in a gasser there is a large hub area...
  11. W

    don't use DJI props they snap 8"

    Did you align the flats on the motor shaft with the flats on the inside of the props?
  12. W

    CX4 WooKong GPS Problems, plus Spektrum DX8 Failsafe settings.

    Just a thought, try turning/rotating the GPS unit about 20Deg to the right, ie.The arrow points 20deg to the right. Unit is trying to get to GPS position but GPS/Compass unit is messed up by amount of magnetic declination in NZ. Thinks it is heading to center but is actualy 20deg out on course...
Top