Search results

The start up sequence will not complete if the configuatoon is not correct.

They will not arm without completing the start up sequence with Naza.

It sounds like a configuratin problem. Could be with x1 x2 and x3 ports. On the Phantom x1 and x2 are to the reciever and x3 goes to the power distribution board, EXP is to the GPS.

You ordered from the CAwarehouse I hope.

The only other country I lived in was Turks and Caicos. Maybe someone else said they didn't have to pay duties, but I sure did. I have been around a bit. Turks just went from 30 % to 45 %. Much of EU pays 50% even on income.

Well said

I had the wonderful experience of living in the Turks and Caicos Islands at a private island estate called Emerald Cay as the Director of constuction and property management for all the properties of the billionaire owner. There were no taxes until September of 2013. There were, however, 30...

I feel for ya too, but don't order them from hobbie king or they can take the life time of most batteries just to get them. I've been waiting 74 days and can't even get tracking info as I am being told to be patient. At this point, if they were standing in front of me telling me to be patient, I...

Ripple was a bad wine from 50 years ago.

That's true, I think ppm id good for modt dji equiptment.

That would be DBUS

Yes. My reciever has two cables to the naza m v2 and the reset is on the bottom side of the reciever and I'e rebound it over and over turning the red blinky out with same result.

Help! I had to replace a control board on my Phantom and all I get is yellow blinking LED's. The assistant says configuration error and I'e done everything I can think of. It seemed like it took the recallibration a couple of times, but always goes back to the yellow blinky blinky thing. What do...

I would have been tickled if it took only 35 days. It's just about double that so far. I finally told them that if they can't have the parts delivered yey this week, to refund my payment.

I have issues with hobbie king too! Been waiting 63 days for batteries. I have inquired 3 times and still no estimated delivery date or tracking info. They just say be patient. I've had 74 deliveries mostly from China, and ALL of them were ordered after my order from hobbie king. When adding the...

Static confusion (ripple affect) should not be a problem with wire in the carbon tube. Unless your talking about the wine.

You can use a bullet and put a heat shrink over it to help keep it intact. Or you could solder the bullet.

Just adds a possible failure point.

I desolder the power cable from the esc and solder one back on thats long enough and zip tie the esc to the bottom of the motor mount. It will stay cooler there and out of the way for everything.

I like the esc under the motor for many reasons. The biggest is having the extra room @the center plate. If you are concerned about power loss use a larger awg from power supply.