Search results

Have talked to DJI europe and they want me to ship it in for a warranty claim, can't say I'm suprised. Haven't decided what do yet, but i suspect its easiest just to RMA it

This is without power to show balance, you Will not be able to this with a powered gimbal

Im going crazy trying to understand this, it all comes down to balance it seems This is my setup with shutter cable attached, then its left heavy. If remove the shutter cable, the gimbal almost always starts correctly even when touching the camera body, but its right heavy. Suggestions ...

hahaha, no Drifting like crazy Even before lift off But it helps flipping trough the 2 modes on the gimbal, it resets it self and is almost level after that

Spent a few hours testing my gimbal today, also in air testing, seems like mine is off balance, as its left heavy. Might post a few videos later today

Turned it by hand, but i also suspect something like you. When i connect my IOSD it gets worse, constant spinning during cali and such. It was much better when my zenmuse was directly connected to the GPS puck.

The "gunc" is there to hide what parts DJI is using, anti cloning technice. I turn the lens downwards before i start cal.

To the mod that merged these threads, These are not the same problems. Have been looking at the zenmuse for a while and noticed during calibration the kamera hits the yaw axis when testing roll, if i put the camera lens down and calibrate it calibrates just fine as it can test the MAX lenght of...

It has calibrated 2-3 times correctly, but the last 10 times noe in a row it does this. It happend both with a2 2.1 & 2.2 Running newest gh3 firmware

It happends during calibrations Forgot to remove it while i made the sample video, but it does happend with it off also

Zenmuse GH3 problems I have a problem with my brand new zenmuse gh3. After cal it tilts the gimball max down to the left, no matter what. Have tried with and without RC input. Any suggestions, the zenmuse is connected to the IOSD trough the GPS hub on A2 as per manual. EDIT: MERGED THE...

For info: Tmotor 40A (pro) and Hobbywing 30A esc are working fine on u5 motors atleast for my part.

Set idle speed to High in naza

The sound is the same that i had when my esc had timing issue, you should bench test the motors with some abusive throttle when you swap your esc and you will avoid this. Hobbywing platinum esc is a good choice

What motors are that ?

Havent tried to be honest, since it wouldn´t test the limits as much as doing it with props

Nop, all motors are fastened the same. And this is always checked before i power on the setup.

Yes, i did the esc calibration, even tried the -110% trick without luck. As for the esc, yes someone with the name Aicy answeared my emails, and i was told to use T40A / pro. If i had S45A already i could try it, but they recommended T40A SleepyC as you might have seen on the video, after the...

Yes i know But this is only for 80+ amps if iremeber correctly. Exchanged some words with customer support at tiger and they recommanded t40a / pro. And that i stay away from simonk Even their new s45a esc If you think it is normal i recommend you to turn on audio....

Woundering if any of you that owns U5 motors have sync problems with them, and if not what esc's are you guys running? Have been testing simonK on these motors with very bad results. Test 1: Intresting parts are at 0:41 1:18 3:52 Test 2 with newer SimonK code: