Search results

  1. W

    F550 wobble after new props

    Purchased new carbon fibre props for my F550. Balanced and installed them and the MR now "wobbles" sometimes when flying and even when hovering...but not at all times. Granted, there was a bit of wind on my only test flight with the new blades...5-10 mph at ground level. But I dont recall ever...
  2. W

    Converting controller on Mastor 2 axis gimbal

    After reading about all the problems associated with the Mastor gimbals (I got a brand new, uninstalled Mastor unit with my f550when I bought it), I am wondering if anyone has experience, suggestions or even if its possible to remove the mastor control board and replace with a controller that is...
  3. W

    setting up the control mode switch naza m v2 with JR 9503

    I am programming the 3-way gear switch on JR 9503 radio with Naza M v2. I am unable to adjust the slider to allow the atti, gps, manual to light up. I have only a small amount of adjustment. Can anyone provide some help? Thanks very much.
  4. W

    unable to connect to computer

    Checking to see if anyone has been successful in running the naza software on a Mac computer with Parallels. Before I go and buy a small windows based laptop, I installed Parallels and then was successful in downloading naza assistant and firmware 4.02. After I connect the naza to the mac the...
  5. W

    Basic question from a basic noob concerning JR 9503 radio bind and next step

    I have purchased a DJI 550 with an ar8000 receiver and naza 2. I also have a jr9503 radio into which I have created a new model. I have performed what I believe to be a successful bind...the blinking lights on both onboard receivers turn solid and the green light on the back of the radio...
Top