Search results

Lovely. I've spent 14 days in Scotland the last 3 years and never seen any of that. Spent all my time on the Old Course...

Yes I'll probably fly LOS, then look at the monitor to see if the bird is pointing the right way, then snap pics or enable video.

I should be getting my FPV gear this week. Any pointers or advice before I slap it on my 960? The camera is built into the Zhaoyun gimbal.

My vibe issues were solved when I centered the camera under, and put the batteries on top and got rid of the camera/battery counterbalancing gig.

Good guess. If that's the case I wonder if he has to make it look evil.

What is an actor drone?

Your vibes aren't too bad in the log as far as I can tell. Strange to see those big differences in the motor values. Not sure about X configs since I don't fly one. Where are the camera/battery mounted?

Very smart!

I set the range on the gain knob in the Taranis to -20 and +20. Changed the center point to 1530.

Ok kloner I'm back at this post, purchasing my first FPV stuff now! Unfortunately that receiver is out of stock. How about this one? http://www.getfpv.com/5-8ghz-32ch-fpv-av-receiver-rc832.html The antennae were out of stock too, so I got these instead. Will these work...

I was searching for an FPV post and came across what I had to do for my G knob to work: I set my range to -20 and +20 and the center at 1530.

Thanks for the confirmation. Any thoughts on making a "plug" attached to the frame? Then to power up you just plug the battery into the plug, instead of a wire with a plug dangling off the frame.

My T960 is grounded for the moment as I'm working on some small improvements. 1. I've had 3-4 occasions where I got a solid light during flight, looked white but might be yellow. I understand that to be GPS interference. My GPS is not very high, just slightly above the two batteries. Perhaps...

I had to do quite a dance to get my gain knob to default at 0. If someone really needs the numbers let me know and I'll look it up. Thanks for the comments on the photo Mike SF!

Yes that is exactly what I did. I had also read that another person used -97 and 97. I tried both and both worked. Then put the end points back to -100 100. You may also run into confusion on the gain knob, which if left at default is at something like -18% and moving it either direction...

All I did was assign it to an open 3 position switch. Up is photo. Down is video. If I leave it in the up position it will shoot a photo every 8-10 seconds. If I leave it in the down position it will shoot about 1 second of video every 8-10 seconds! So to shoot continuous video I flip it...

I've got a solid setup for my NEX5 and remote triggering of photos and/or video using one 3-position switch. Taranis TX FrSky RX Flytron sLED v2 - review here: http://goo.gl/rtloE4

True. Also good to keep flying and building up experience.

Last night... I've got my gimbal and camera pretty dialed in. So that last couple of flights have been sans-camera/gimbal and just for the fun of flying. Didn't even change the gains and still flies fairly well. I'm getting 20 minutes without camera/gimbal/rails on two 5000mAh batteries.

Question: I'm balance charging my two 5000mAh 6S 35C batteries and at the end each cell is showing ast 4.2 volts on the charger. But when I check them with my FrSky cell voltage monitor the cells are clocking in at 4.17-4.18 and even one at 4.16. Is this a concern?