Search results

My point wasn't that it was unlikely someone was stupid enough to do this but that it was unlikely 2 pilots would have been looking in exactly the right direction at exactly the right fraction of a second to both see it, and then for it to be immediately blasted all over the pop news. The point...

Gotta call BS. Two commercial airline pilots spotting a black quad at 1500' while on final is about as likely as a 757 fitting into a 14' diameter hole. At least we know this agenda is hard-coded now too.

These don't work at all when you speak German. :upset:

Yes. Read this thread.

Try the new DJI 10-3.8s. You are the perfect tester with lots of APC 10-5 experience on two different motors.

I must be older than I thought. A flat is a flat area on a shaft otherwise round - typically for the purpose of locating a set screw. Maybe its regional RC dialect. My metric prop reamer is a Fox. Heard of Fox? :D

They have flats inside the bore. I am running these reamed to 8mm then reduced to 5mm (HeliDirect Reducers) on TBS 900s and 4S. My 5.25 lb. 8400mA LR FPV quad flies great! Very smooth and the motors are barely warm - but its still cool here...Anybody need 4 Graupner 9-5s?

Not once. But I had countless problems with internet customers trying to scam my business in every possible way imaginable for years and years. Being in China and operating on large volume and small margin it becomes much more likely that someone in your position is looking for a free extra set...

We can't tell you what PS you would need. You'll want either 12V or 16V depending on whether you fly 3S or 4S and it needs to supply enough current to hover your machine. You would measure this with a watt meter or guess high from motor/prop charts. Here are some to choose from.

Welcome! I'm fairly new here too and you got my fleet beat hands-down. One Trex 700 stretched from a 600ESP and an FPV quad that should maiden Sat. Wisconsin will alway be home since I grew up there and have lived in Green Bay, Appleton, Madison, and Lake Mills in that order. Left in '05 and...

They are notched. You have to run an 8mm reamer through to install adapters.

Has anyone directly compared these to APC 10-3.8s? I know my MT2216-11s run hot on APC 10-3.8s on 4S but am hoping these will do better because they are so thin.

Cut it free by sawing through with dental floss.

What is the diameter of the Top Flite shaft? I wonder if the magnets would support a drill blank the diameter of the motor shaft with points machined onto the ends and no cones at all.

Yes but I don't have room for a 55mm lens on my setup. Hopefully the little one works.

I just ordered this one. Hope it works.

I found this one. Only $11 but they wacked me $12 for shipping (UPS only).

What was faulty with the NAZA?

Very interesting. How do I install one on a H2?

Can you describe the setup you used to test the motor vibration with your phone?