Search results

You should not be using any wires from home depot, those wires are not ment for this application. go to castle creations and buy real silicon wire ment for RC use. Sounds like your end points are not calibrated on your esc properly also. you need to find out how many amps your motors are pulling...

you will need to be more specific and tell us what wires, are you extending your esc's dc supply, the motor wires, or the esc, servo wires. Typically you do not extend the esc's dc power wires without adding Caps to stop the voltage ripple that will occur with longer supply power wires. When you...

I think this is the problem. you have to use certain versions of assistance software to upgrade the FC all the way to 4... version. I had a tough time with this problem you are having. I started from scratch back at the beginning firmware and assistance software and followed the upgrade...

if you lost one already, why would you try again to loose one? you need to go google images "antenna donut" and understand the position of your transmitter antenna will greatly affect your range. Quote - "If I do a range test at 30 paces and get a good response then I should be in control at...

Yes, Bartman is correct.

I think you should take Kloners advice, remove all props, spin up motors and apply load to motor(i.e.: slow down with your hand) and see if one of them has not torque

Mike must know about the LED codes, he wrote a 22 page write up on how to use the copter, included in this write up, is a complete color chart that Mike has added and must have looked over, wait, maybe he did not read it and just regurgitated info and copy and pasted screen grabs into the...

it is going into failsafe because your transmitter is not set up correctly, you can see the two flashes on the led that tell you you are having transmitter issues. GO READ THE MANUAL and setup your transmitter correctly and this problem will evaporate...

If you watch the video you can clearly see this goof ball leaving his transmitter on the desk and waiting for the copter to go to failsafe. It appears his Tx is not calibrated correctly and is not centered. Double flashes. If you don't want to use the feature, don't enable it. The same can be...

Sorry to hear about your loss. I am currently building a X8, WKM, T-motors U7's, T-motors 17" top prop, 18" bottom prop, 2x10,000 6s, iosd mini, 1100mm diameter, tbs sony 69 fpv camera, immersion uhf. I too am concerned about a brown out from voltage ripple or voltage drop under heavy amp load...

econfly is right. Also why would you every leave any copter at idle on the ground with the transmitter out of your hands? bad flying etiquette to idle copter on ground, it is not a gas model, but a modern computer controlled electric multi rotor that never needs to idle that long on the ground...