Search results

WHen you do some more tests pls tell us if its better. :)

Hello guys do you reflash to SimonK firm your escs???

Hmmm nice case.. I have put a carbon plate 1cm above the HF pro.. :)

Hmm i dont like this so much?? Can i do something with heat and hands??

No one??!

WHen you give it a try pls tell me what are the measurements of the motors..! :)

Guys what are the measurements you take on the end of balancing???! i think everythin under 0.09 is great right?? Thank you

It depends on the day and what i want to shoot..! If your video is blurry you might have vibes..!

yeap i shoot very good videos..! I tune the cam right and i have a cs8 with cs gimbal + radian..!

Yeap thats what i said i will not change anything i will leave the little play..!

i will leave it as it is.>! and i will check it on flight..!

I found the problem guys..! I put 2xwashers that Bartman send me not one and the lateral play went away..1 i couldnt see the up and down play because of the magnets.. Now i have 0 play..!!! Also on some you could not put 2 washers then you have to un tighten the shaft and you pull it out a...

Do you think its a problem.. the lateral play is very very small :) :)

What can i do about tracking?? do you know??!

Never crashed an the play is very very small..!! with the stock there was no play.. Also i cleaned everything when i opened the bearings..!

I baught these here..! http://www.bocabearings.com/bearing-inventory/21489/rc-brushless-motor-bearings/ceramic-lightning-abec-5/t-motor-mt2814-710-kv

Hello guys i have the 14x4.7 APC SF and i remove them from my Octo (without haveing problems) in order to check the tracking on the balancer...! I saw that all the props have tracking from 1mm to 5-7mm max..! Why is that??

First of all i did everything with Barts perfect tool...! THe Tool is pefect GUYS...!! Secondly i lube them because Sunil from Boca told me that there is not problem to lube them on the outside of the bearing..! And the play is from Boca bearings..! !!! when i do the motor up and down there is...

in order to have fewer wires :) thats all :)

Great... do you know why??