Search results

Yes Ken that is exactly what happened a couple of months ago. The same thing. It went all wonky and tried to fly away. I was almost within reach so I managed to bring it back. I was quite proud of myself that time. this time I was not so lucky.

Hi Dave: what do you mean by erratic behavior?

I have a Navi-Ctrl V 1.1 and the firmware I don't know it was up to date in Feb. I have not updated since. Shaun

I think you might be right Crash. because of lack of experience and patience I might not have waited long enough for the ch to do its job. I think I was more concerned with getting it away from the public than getting it back. I guess my other concern is why it went the opposite direction...

I don't know. You might have to clarify that question.

I am using a jr x9503

here are the files.

no Bart that is what makes it so hard to pinpoint because it was flying away and would not respond. I have a sd card in and do have the files will try to upload them.

here is just before and just after I lost control.

I had a very bad crash a few weeks ago. I have a ADL 6. The flight started out like any other, I was flying in manual taking some shots with my gopro. About 2-3 minutes into the flight and about 60ft high and 150-200ft away I decided to bring it back. At that point as I pulled back it sped up...

Hi: I guess I should get in on this too. I wasnt going to until I had a bad crash the other nite. so here I am. SM

Is it the motors or the control board getting hot. Shaun

the props I am using are slofly. the areobot I don't know.

Hi Ross,they sell them at Quadrocopter.us but I haven't received a reply on what the advantage if any would be for my AD6. Shaun

Not sure if last post went through. But has anyone tried the 13x6.5 aerobot blades? Shaun

so I drilled out a 5/16 flat washer, it worked like a charm. not sure if they are all like that but when everything has to be so precise I'm not sure what happened here. SM

Your right Bart the hole is oversized but it really should be a slot to allow the pot to go up and down. I'll try the thin plywood idea. thanks

mount Hi Bart: here are some pics you can see at the bottom of the thread how big the hole is. Shaun

I'm having another problem with the pro200 mount, the nut to hold the roll pot gets loose. The hole that the pot shaft goes through the frame is quite a bit larger than the shaft. When I try to tighten it it loosens after a few flights. The last flight could have been a crash but luckily I had...

Had first flight with av200 camera mount. went well. Canon 7D is very heavy. I have been flying with gopro and a small sony it will take time to get comfortable with the Canon. Mount works well not impressed with the way the potimeter is secured to frame comes loose alot. Must be careful to...