Search results

The deformed part I think is about where the grit started and I tried to reverse the nut but no luck it was too late. The aluminum is way too soft for prop adapters they should at least be air craft aluminum or a heat treated type aluminum. And I really hate the "Cone" nuts I have lost more of...

Makes sure that the stem on the motor adapter does not have and grit or sand gains in the threads before trying to remove that nut or this will happen. And I only like another 5% have the gains set on my 810 also.

Yea I went through the accel and gyro calibration and I hope everything is working better now. But today is another flight test with the new gain settings.

Cheap small ebay gimbal for a gopro 3

Yes I had flown the hexa a few times trying to get the gains set in the naza for the 680 build. Then after I changed things over to the 810 size I also flew it a few times before changing things over to the laptop. And after connecting the naza to the laptop the software bring everything up like...

I just reversed 2 of the wires on the (3) motors that were turning CCW and made them turn CW

This flight is with the new 15X5.5 props and simple BGC gimabal and gopro. Was kinda windy so I can't figure if its my gains or the windy so I will try another flight without the wind if possible. I just can't figure out why my gimbal went into spasms at the last the way it did. The gins I had a...

That's why I ask the FAA not to give me back a lot of double talk. Just a simple and plain yes or no

Most of the ones that I have listed I have never ordered from

DJI Inspire

I just received this e-mail from the FAA this morning. Thank you for your inquiry. In the Interpretation of the Special Rule for Model Aircraft, the FAA determined that model aircraft flying under first person view (FPV) could not meet the visual line-of-sight requirement of hobby operations...

This is on the FAA website. https://www.faa.gov/uas/media/Part_107_Summary.pdf

This is from 107 section and its Section 335 about hobby flying. SEC. 335. <<NOTE: 49 USC 40101 note.>> SAFETY STUDIES. The Administrator of the Federal Aviation Administration shall carry out all safety studies necessary to support the integration of unmanned aircraft systems into the...

Addictive RC... http://www.addictiverc.com/ Aerialpixels... http://aerialpixels.com/ Atlanta Hobby… http://www.atlantahobby.com/Store/pc...idCategory=869 Altitude Hobbies… www.altitudehobbies.com/new-multicopter-gear DIYQuadCopters… www.diyquadcopters.com/Home_ep_1.html Espirit Model...

A Main Hobbies -- Your One Stop Hobby Store Align Official English Site -- The new official english webpage for Align! Avant RC -- Avant RC Byron Originals -- Home of Byron Fuels Canomod -- Custom Canopies Castle Creations -- Known for their ESCs, like the ICE and HV line. Edge Rotor Blades...

Do folks that fly for hobby fall under this new licensing?

HobbyKing has a USA warehouse now

I stopped using my desk top for the naza v2 and I put the program onto my laptop. After going through the setup again I took the hexacopter out for a test flight. It never got off the ground each time I tried. Put the hexa back on the bench and went through the program again and found nothing...

Hopefully they will do more R&D before pushing it out to the public

I was just wondering about the thrust because I could not find any info in that system