Search results

I've been trying to dial in my new build - rctimer x650 clone, rctimer 30A escs (simonK), 2814 motors, flysky, NAZA, 5000Mah 4S, and am having an issue. Here is the list of things I've done already - balanced multirotor, balanced props, reinforced crappy rctimer booms, calibrated ESC's to...

I've been trying to dial in my new build - rctimer x650 clone, rctimer 30A escs (simonK), 2814 motors, flysky, NAZA, 5000Mah 4S, and am having an issue. Here is the list of things I've done already - balanced multirotor, balanced props, reinforced crappy rctimer booms, calibrated ESC's to...

Set up RCtimer 30A simon K ESCs in my Quad controlled by NAZA. When I arm the quad, it fires up suddenly at 50% throttle( Does not take off when i slowly increase the throttle) and doesn't increase until I hit the 50% mark on the throttle. The esc does not seems to have a throttle range that I...

I'm pretty new to this stuff, so if I'm completely off somewhere, excuse my ignorance....I recently bought the RC Timer 30A esc's w/ simon K for a build I'm doing and haven't been able to get them into programming mode. I've tried two different programming cards (Turnigy and Hobbywing) with...

I'm trying to set up my flysky 9x with my dji naza and am having some problems. I've got the ch 6 from the Rx heading into the U port on the Naza and on the radio, I've got ch 6 set to the gear switch. When I fire up the assistant software, however, it has the U channel bound to the throttle -...

I have a heavy lift hexa and due to adding a gimbal, am looking into mounting my dual 5200 MAH 6S batteries on top of the copter. I've considered mounting them on the bottom in between the gimbal and the copter, but this would require much additional modifying. Does anyone have any thoughts or...

Forgive my noobness. I'm starting my first quad build. So...It would seem as if most receivers, control boards, and stabilizing modules are male three pin servo. Can anyone give me a decent place to buy female to female servo wires? Seems to be a bit difficult to find and seems like the most...

Never been used and still has the plastic on the screens. I recently bought this to control the gimbal on my multirotor, but realized it didn't have the right output signal for the stabilizer system I wanted to use. Could return it, but its a big pain and a 15% restocking fee. Yours for $130...

I've been trying to figure out whether the devo 10 can be wired to radian stablilizers using spektrum, ppm, or s.bus with little success. Wired in this way, the stabilizers are daisy chained to one another. The radio manual states that its (DSSS) Direct Sequence Spread Spectrum, but very...

Hello all, Brand new to the forum. I have a 950mm hexa that I've had for a couple of weeks now and its flown 5 times. Tiger motors, Maytag ESC's, Wookong - M. It flys great - really smooth and responsive; however, one of the motors takes a while to fire up. On the hexa, if it is oriented...