Flygirl...How difficult is it to mount, balance, set up the Tarot T-2d? I would spring for the Zenmuse H3 except I'd then have to upgrade my gopro 2 to the gopro 3. I like the simplicity/integration of the zen.
I damaged one of the original blades so I am unable to test/compare.
Are there better plastic blades to purchase than the DJI's? Ive seen some discussion about different pitches.
My 550 has the orig DJI motors and 4s batteries.
Thanks. B
Purchased new carbon fibre props for my F550. Balanced and installed them and the MR now "wobbles" sometimes when flying and even when hovering...but not at all times.
Granted, there was a bit of wind on my only test flight with the new blades...5-10 mph at ground level.
But I dont recall ever...
After reading about all the problems associated with the Mastor gimbals (I got a brand new, uninstalled Mastor unit with my f550when I bought it), I am wondering if anyone has experience, suggestions or even if its possible to remove the mastor control board and replace with a controller that is...
I am programming the 3-way gear switch on JR 9503 radio with Naza M v2.
I am unable to adjust the slider to allow the atti, gps, manual to light up. I have only a small amount of adjustment. Can anyone provide some help?
Thanks very much.
Checking to see if anyone has been successful in running the naza software on a Mac computer with Parallels. Before I go and buy a small windows based laptop, I installed Parallels and then was successful in downloading naza assistant and firmware 4.02. After I connect the naza to the mac the...
Ed, thank you. I have found and watched a few videos. I have properly connected the naza mc to my computer following the proper sequence. I have the latest assistant installed. When I try to select mixer type and click motor test, i continue to get "please connect to the controller".
Any...
I have purchased a DJI 550 with an ar8000 receiver and naza 2. I also have a jr9503 radio into which I have created a new model.
I have performed what I believe to be a successful bind...the blinking lights on both onboard receivers turn solid and the green light on the back of the radio...
Bart, second vid is great. Unrelated question regarding the The Multi4S charger which you recommended in earlier post... it "also needs a power supply but it will work great with a simple $20 unit from amazon or somewhere similar." What is the power supply? Is it a converter? Thanks. Bill
bart, your comments make a lot of sense. as you prepare the next video, would it make sense to provide us at this time with a general list of items to purchase, or at least begin discussing and getting pricing that we can share? You indicated that you plan to use tiger motors. it seems to make...
Super! Very informative and well presented. Thanks in advance for the amount time you are dedicating to this. Honestly, without this type of hands-on instruction I wouldn't try to build a copter... would have ended up buying a rtf and not have the knowledge I am sure will come with the build...