When I shift the setting to low 2 of the 4 motors spin at a very slow rate and 2 do not spin. When I move between low and recommended all 4 motors spin upon arming. A few seconds later all 4 motors will stop unless I throttle up. It is weird because I recalibrated all 4 motors 1 by 1 using the...
I was able to arm with disconnection of the USB. When I arm the motors start spinning. I have tried all of the motor idle speed settings with the same results. Any suggestions? Thank you again.
Bartman: I see a failsafe options option but not a check mark. Most of boards I read do not have the Naza Lite Assistant pictured but the full version. 2.2 I believe. I find it odd that there isn't even a button to click to upload from the assistant to the unit.
Cootertwo: I will try after...
I installed my Naza-M Lite and this is what I have so far.
ESCs manually calibrated using RX
Then everything wired channels 1-4/escs/voltage monitor/3 channel switch for flight modes
Confirmed through assistant that I have:
Sticks calibrated with motion in same direction as slider for all 4...