Recent content by periquira

When I release sticks at IOC mode, does the quad stays with position hold activated?

This is a great idea, i will try tomorrow. I am using 4s 10.000mah lipo for engines and a 3s 450mah for naza. 12x4.7 = 17minutes of flight with fpv gear.

I think it was not a broken prop because quad did not fall to the side of any specific motor, but to the left side (this would be possible only if both props broke together). You was using the newest firmware?

Nobody?? Especially the number 3, please, somebody here knows how to activate RTH without turn off the radio? Can I stop the RTH and get control during the flight?

I am starting with Naza and I have 3 doubts: 1 - Can I use a separated 3s lipo to power naza and another to power my engines? If yes, what is the correct sequence to turn on? 2 - What is the correct timing to use on Turnigy Plush 60A esc? 3 - How can I activate RTH with a switch? (without...

It is difficult for me to call someone to film. I will try tomorrow.

I have the same firmware on both. I left the sticks released as long as possible (otherwise I would crash on the trees - something like 15 meters away). At this distance I consider that the center point was forgotten.... I will try to recalibrate the trims and see what happens.

I flew today and it seems to be much better. AL can now be engaged with wind and the side that faces the wind does not rise. I can go against the wind with AL without loss of command (before, if the wind were strong it had no command). I need to make more flights to confirm these impressions...

Do I need to redo temp cal and throttle range? In sumary, what are all the calibrations I need to redo?

I will try it asasp, probably tomorrow and than I give you the feedback.

But these guys that crashed with Naza flew ok and the other that did not crash are flying ok. On the other hand, hfGPS never works, only on HF staff videos or in a dead wind situation or with the pilot's care.....

Hf, now you have the info. Where is my answer?

Nice to hear that!! Somebody else? And with gps?

I have the same problem without wind. If I get some wind, it is worse.

I would like to hear about people that use naza (instead of wkm) on heavy multirotors. With heavy I mean 3kg or more and 600 mm or more... Do you have a picture of your build to let me make a comparison? This would be great!