Recent content by luchtshot

We installed it in one of our mikrokopter octocopters, this little upgrade, new firmware 90. now the octo is hovvering super steady nice.! I like the upgrade.

I did install the 58 firmware for the V1 no xbee ( I don/t have a xbee) I try to use a jeti box The picloc started good and, did communicate with the tools58 also ok.. If the wrong version is loaded How do you notice this?

Hi All, I use the v1 picloc3xpro sn25 (one of the first) with the v55 firmware for some time now, but some time's the stabilization is not working wel. I only use the rol and tilt axes. Th pan is used direct from the receiver. Yesterday I did decided to upgade to 58 and try the new 58 firmware...

For sale a nice mode 2 graupner mx-22ifs transmitter included 2 jeti rx. specs: 1x graupner mx-22ifs with jeti TG2 transmission module 1,5 year old 1x lipo 3 2800 tx accu 1x JETIBOX mini display is used for data readout and parameter adjustment of hooked up equipment. 1 jeti rsat2 long...

Hi guys, I tryed to upgrade one of my piclocs, where can i find the latest release for my picloc3x?

HI All, Small update here, after all the problems we had, now we are quite happy with the piclock 3x pro now. I did put hd055 in the pc and the pl and use it with an octo, av200. I use the pc for tilt an roll, without the slew function, but with stabilation. The pan of the av200 is comming...

OK, sounds nice, I have a 2nd piclock now configured with e055 and give it a go. Do you have home hints for the config for the av200? The more you tweak the better it get. I found a kind of drift in the tilt ax. Tomorrow more for now.

Ok, I did the above instruktion and now it works fine. I have a mx12 tx now for the cameraman. Thanks for all the assistance. Now to configure the pl with the mx12 and the av200-360, any tips? regards Hans

There is now 55 fw on th pl. the toolz I use is vE055. Version v.HD3x_H055 from George site crashes after 10 seconds and leaver piclock unaccesble. The gimabal is a av200pro. I think I go for a old model jeti controlbox. If anybody has one for sale please let me know. :-)

@borisS If I leave the servo's connected the toolz crashes with an error and I'm locked out. Hopeful the toolz tool gets better soon.

After some tweaking now it starts to work. it is a bit labor intensive, it works I use tools E055, and without servo connected you can chance parameters and store them in the eeprom, disconnect usb and connect the servo's an do the test. and so on. All are bench tests, later tests while flying.

I have the same problem, 13" xoars are ready to mount, but tere is little room between those engines. Any one an idee?

I did dropped a mail to George, hopefully he has a spare minute to view. Out of the box the pl works, but it needs a little bit of tweaking on rol and tilt. Pan we use direct out of the receiver. Now every time the anoying error box appears, you click continue and quickly make a chance, some...

Hi Graham, can I get a copy of the latest fw and tools? I like to try it on my piclock here.

Hi all, Now our octo and quadro are flying again I did install the piclocks. Now I found that the 2 3x piclocks I have one with 53 and the second with 55 firmware. I try to get control of them. The 53firmware version won't see the futaba receiver inputs at i1,2,3,4 even when the piclock is...