Recent content by AEMontoya

I bought these as spares and never used them. Asking for $45 shipped anywhere in the CONUSA. Not selling individually. Thanks for looking. 3 CCW + 3 CW 8 mm bore

This H3-2D has been in the air about 10 times, with no crashes or hard landings. It has never shown any issues. It also has the older firmware, which allows for ramped, perfectly controlled tilt as well as tilting above the horizon. I can also e-mail you the appropriate assistant software to go...

This is an RC Carbon foldable Y6 with custom, foldable landing gear. The frame measures ~600 mm from rotor to rotor, and will accommodate up to 14" props (15" props will fit, but it's cutting it close). It has a dual lipo mount on the underside, is tall enough to fit a decent gimbal and camera...

Selling premium 70A MGM 8s ESCs (brand new) for $500 (cost over $650 with shipping). Come with optional power switch, newest FW, and up to 1,000 Hz refresh rate. I bought them with the notion of using them in a large quad, and eventually a monster X8. Here's a link to them on MGM's website...

These motors have seen literally one flight on a large quad. I paid $195/motor plus taxes and shipping fees. I am selling all four for $700 shipped, OBO (that's $175/motor and no taxes or shipping fees). I am selling them merely because I have chosen to go another route besides a large quad...

These motors have about 10 seconds of run time on them; I put them on a hex, spooled the motors up to make sure they rotated the correct direction, and never powered them on again. Everything that came with them is present, including mounts, screws, adapters, and boxes. $290 shipped (extra...

**SOLD** Up for sale are four brand new 20x6.7" Mejzlik multirotor props. They are perfectly balanced, and weigh in at only 28 g. They are also surprisingly rigid, and are flawlessly made. The hole pattern is: Center hole = 4 mm Auxiliary holes = 3 mm with 12 mm center-to-center spacing 2CW...

I am trying to fit the KDE motors to 20 mm booms, and have had a very hard time finding motor mounts that will work. I contacted Aeronavics over a week ago, and still no work from them or other way to find out. I'd greatly appreciate your help.

Hi, Are these the Sky Jib motor mounts you finally got to fit the KDE 5215XF motors you have to 20 mm booms? http://aeronavics.com/products/shop/skyjib-spares/engine-mount-kit-skyjib-xl/ Thanks

Hi, Is your Flexacopter still for sale? I am interested.

So, is this multirotor still for sale?

I just wanted to report that the dual RX setup that I proposed in Post #93 works. Although I don't have a Zenmuse to test with, I have tested the setup with a set of spare servos, WKM, et cetera. Everything works as per the diagram on said post, where RX 1 = 6208 and RX 2 = 6308sbt (I ordered...

Whatever you do, don't buy the retracts in the link you sent. Those are woefully inadequate for a machine like the s800 (the retract units themselves are flimsy and underpowered. So is everything else about those retracts). The Pimp Your Copter retracts are not much better (most likely cheap...

Hi All, Please PM me if you have a new or like new Futaba 6308sbt for sale. This is the only receiver I would like; please do not contact me regarding any others. Thank you, AEM

Yes, I think the design should work as well. What drives me is the desire to have a simple setup with no need to plug/unplug wires for switching between one- and two-man operation or when separating the gimbal system from the multi rotor. Moreover, I would prefer to only have to pay for and...