Flipped again

[DesJardins]

Well this is my last attempt at getting such a simple machine operating after 3 weeks of sudden uncertainty.
Rolled on me again, intermittently after 20+ fantastic flights.

I have upgraded the firmware this morning and have replaced the rear left side motor and ESC as that was the dropping out side.

If it's the bullet connectors that's rediclous, if it is bad v1.8 firmware I was running before that's rediclous.
Ok, rant over so I'll post up results after a good amount of trying.

No way I'm putting FPV gear on this thing

 

[Kilby]

It probably is your bullet connectors. They are pretty much proven to be flakey. If you don't feel like taking them off and soldering wires on, give them a good squeeze with the crimper to make sure they can't come loose. Not to much though.

-Terry

 

[kloner]

if the craft gets picked up by the arm alot you can crack a motor wire too. You can find that by starting it in your hand without props and wiggle motor wires. it takes all three or it studers and doesn't spin

 

[DesJardins]

I'll check all of the above and if nothin studders or cogs out with wire movement I'll solder to just be done with it.
:shrug:

Thanks!