Warning! suspected bug v5.14a beta!

[renedu]

Today Ihave loaded latest firmware v5.14a beta and all went well.
Launched myCS6 and flight went very well (good response and stable flight in GPS mode).

Then Iswitched to Going-home (X3), drone flipped immediately to the right, switchback to normal, but drone was not able to recover. Drone fly at a height of 30m. Flight end into a crash, 2 booms and one landing gear broken, damaged gimbaland a defective Sony NEX5N (no visible damage at all).

I assume abug, what do you think?

 

[DennyR]

Did you have your failsafe set above 10%....

 

[Tonphis]

Oh, Sounds Bad. A few days i Update also to these Version. And i want to use poi Feature.

Any one out there also problems with These Version?

 

[HEX junky]

I've been using 5.14a on my 450,550, and S800. Using POI and RTH. No problems.

 

[Tonphis]

@renedu which Typ of tx are u using?
Also with ppm?

 

[renedu]

@renedu which Typ of tx are u using?
Also with ppm?

A Futaba T8 with a S-bus receiver

 

[Tonphis]

Okay, today i fly And all was normal. Nur when i go Down a Little Bit fast my Copter will Shake verfy much from left to right. It come without any warning very heavy

 

[renedu]

Ok, this is more or less normal when you go down.....
Response from DJI Support was that they extensively tested the Go-home function with rev. 5.14a, so there must be something else wrong....
Did you try the Go-home function?

 

[Tonphis]

I am Not Crazy. But i have Check. It Works but it Swing more than 45° to the left And right

 

[renedu]

There is some shaking when you go down, but more than 45 degrees is too much!

 

[Tonphis]

Yes realy!

But i think it could be the wrong cog Dimension

 

[Dewster]

I am Not Crazy. But i have Check. It Works but it Swing more than 45° to the left And right

You may need to raise your gains (Pitch and roll). Higher gains will make the craft resist change to turbulance. Just don't over do it because your craft will be harder to control and oscillate.