hello everyone,
last time i went in trouble, this forum was the place that helped me, thanks so much!
I successfully connected my naza v2 based multi to my pc now, and am trying to calibrate the transmitter - turnigy 9x. the RX is connected as follows : ch1-4 are connected to A,E,T,R accordingly, and 6 to U, 7 to X2
GPS is connected to the PMU.
When trying to calibrate the RX, the AETR channels arent steady, and seem to "flicker" between green and black. Also, even though channel 6 is connected to the U channel, i cant seem to change the settings of the mode changer, its stuck on the far right. finally, when powering up, i get a "tx mid point error" on the assistant that says is the reason for the failure.
Also - i cant seem to update my naza firmware , getting an error every time i try.
any help, anyone?
thanks so much again
Andre
last time i went in trouble, this forum was the place that helped me, thanks so much!
I successfully connected my naza v2 based multi to my pc now, and am trying to calibrate the transmitter - turnigy 9x. the RX is connected as follows : ch1-4 are connected to A,E,T,R accordingly, and 6 to U, 7 to X2
GPS is connected to the PMU.
When trying to calibrate the RX, the AETR channels arent steady, and seem to "flicker" between green and black. Also, even though channel 6 is connected to the U channel, i cant seem to change the settings of the mode changer, its stuck on the far right. finally, when powering up, i get a "tx mid point error" on the assistant that says is the reason for the failure.
Also - i cant seem to update my naza firmware , getting an error every time i try.
any help, anyone?
thanks so much again
Andre