Hood49
Member
Hi All,
I have been spending a day on trying to figure out what I am doing wrong.
Situation: I have a Taranis with the 2.0.17 firmware and have a D4R-II receiver that is bind (D8/8 channel)
Problem is that I always get a warning beep/vibration warning every 5 seconds.
When doing a range check (next to the bind button on the Taranis) I get "0" as value. So I guess that it is a range warning that I am getting every 5 seconds. Receiver led is green so I guess it is bind.
However, on the main screen of my Taranis I can see that signal strength is FULL. Weird. In Cleanflight it recognises all the controls (Pitch, roll, yaw, throttle, switches,...)
Very annoying this beep, I cannot get it to stop. I have tried everything: pulling out telemetry, recopying the model from companion,...
Maybe a faulty D4R receiver?
Anyone had this before?
Cheers.
I have been spending a day on trying to figure out what I am doing wrong.
Situation: I have a Taranis with the 2.0.17 firmware and have a D4R-II receiver that is bind (D8/8 channel)
Problem is that I always get a warning beep/vibration warning every 5 seconds.
When doing a range check (next to the bind button on the Taranis) I get "0" as value. So I guess that it is a range warning that I am getting every 5 seconds. Receiver led is green so I guess it is bind.
However, on the main screen of my Taranis I can see that signal strength is FULL. Weird. In Cleanflight it recognises all the controls (Pitch, roll, yaw, throttle, switches,...)
Very annoying this beep, I cannot get it to stop. I have tried everything: pulling out telemetry, recopying the model from companion,...
Maybe a faulty D4R receiver?
Anyone had this before?
Cheers.