bacontriangle1121
New Member
Hey guys,
Sorry if this isn't the appropriate place to start this thread. I'm not very familiar with these forums.
Anyway, I recently finished building a custom V Tail quad and I am using iNAV on the Omnibus F3 as the flight controller and firmware. The problem is that I cannot seem to get the OSD to work. More specifically, I am getting the actual FPV video feed on my monitor but without the OSD overlay. I have OSD checked in the "configuration" tab and the wiring to the flight controller appears to be correct so I'm not sure why I'm only getting video with no OSD . I can't be a broken OSD chip right, because the video feed is successfully going into and out of it? I would appreciate it if anyone could help me figure this out.
Thanks!
Sorry if this isn't the appropriate place to start this thread. I'm not very familiar with these forums.
Anyway, I recently finished building a custom V Tail quad and I am using iNAV on the Omnibus F3 as the flight controller and firmware. The problem is that I cannot seem to get the OSD to work. More specifically, I am getting the actual FPV video feed on my monitor but without the OSD overlay. I have OSD checked in the "configuration" tab and the wiring to the flight controller appears to be correct so I'm not sure why I'm only getting video with no OSD . I can't be a broken OSD chip right, because the video feed is successfully going into and out of it? I would appreciate it if anyone could help me figure this out.
Thanks!