coreyperez
Member
I know there are a few different places I could have put this on the forum, but figured this was "general enough" that I'd just ask it here.
I broke my Duo (ripped SMA antenna bulkhead off PCB) and opted to "self repair" vs. sending into Immersion. So for a couple dollars worth of Ebay SMA terminals I was back up and running. BUT, while making the repair, later found out that I had cut through one of my LEDs. Now I'm trying to source them (correct size/voltage), but I'm having a hard time determining the correct size for replacement.
Any help is appreciated!
Corey
The exact moment I identified I cut through the LED while doing the "upgrade":
The initial "repair":
I broke my Duo (ripped SMA antenna bulkhead off PCB) and opted to "self repair" vs. sending into Immersion. So for a couple dollars worth of Ebay SMA terminals I was back up and running. BUT, while making the repair, later found out that I had cut through one of my LEDs. Now I'm trying to source them (correct size/voltage), but I'm having a hard time determining the correct size for replacement.
Any help is appreciated!
Corey
The exact moment I identified I cut through the LED while doing the "upgrade":
The initial "repair":
Last edited by a moderator: