Naza v2 issues help!!!

[protosflyr]

G'day guys

I am stuck I have set up my naza v2 all working perfect all modes and fail safes are working only issue I have it I can fire up 3 motors but 1 motor will not fire up just beeps constantly any ideas what this could be I have been at it for hours and it's killing me lol

Radio system dx8 Rx is a 6 channel with sat

2200 battery
Dji motors and esc's
Pmu with gps and Bluetooth module


Cheers in advance


Sent from my iPhone that had a mind of its own!!

 

[rilot]

Swap a motor connection around on the Naza output and see if the affected motor still refuses to turn. If it still won't turn I'd suspect either an ESC failure or a motor failure.
If it now does turn but the one you swapped now doesn't, then it's a Naza problem.

 

[blade strike]

G'day guys

I am stuck I have set up my naza v2 all working perfect all modes and fail safes are working only issue I have it I can fire up 3 motors but 1 motor will not fire up just beeps constantly any ideas what this could be I have been at it for hours and it's killing me lol

Radio system dx8 Rx is a 6 channel with sat

2200 battery
Dji motors and esc's
Pmu with gps and Bluetooth module


Cheers in advance


Sent from my iPhone that had a mind of its own!!

If it just beep, sounds like the esc plug is in upside. Make sure all plugs have signal wire pointing down going into the naza.

 

[protosflyr]

Thanks guys had a close look and moved the single pin out of the way thanks for the help guys and for pointing me in the right area

Cheers brad


Sent from my iPhone that had a mind of its own!!