So I swapped my ****ty Servo based Gimbal for a kick *** AlexMos Brushless gimbal and all was awesome!!!
I then tried to hook up the cable from the naza to the RC in port so I Could Pitch form the TX. But I thing I swapped the direction of the cable and after that my Naza is doing the following
Boots up with the usual beeps and some green flashes then it blinks orange in a normal pace. So I was thinking ok Failsafe mode. Naza SW to the rescue. But no!! I hook up to the Naza SW and get nothing on the TX RX connection. Normaly when I move the sticks naza SW shows me that. Now that is not happening. So I opened up the Shell of the phantom ( ugh hate that ) Located the RX and hit the bind button. Normally its supposed to blink red when I do that but the RX is DEAD!!. So i grabbed a Futaba RX hooked that in and tried with my futaba controller and DEAD! Naza will not find my TX-RX what can I do? New naza???
video to show you guys!
http://youtu.be/x02VUHzcE7I
I then tried to hook up the cable from the naza to the RC in port so I Could Pitch form the TX. But I thing I swapped the direction of the cable and after that my Naza is doing the following
Boots up with the usual beeps and some green flashes then it blinks orange in a normal pace. So I was thinking ok Failsafe mode. Naza SW to the rescue. But no!! I hook up to the Naza SW and get nothing on the TX RX connection. Normaly when I move the sticks naza SW shows me that. Now that is not happening. So I opened up the Shell of the phantom ( ugh hate that ) Located the RX and hit the bind button. Normally its supposed to blink red when I do that but the RX is DEAD!!. So i grabbed a Futaba RX hooked that in and tried with my futaba controller and DEAD! Naza will not find my TX-RX what can I do? New naza???
video to show you guys!
http://youtu.be/x02VUHzcE7I
