Himhoe
Member
I have an ESC loaded power distribution ring for an okto. It comes already addressed and ready to go. It has a single EC5 connection if you want it. Sells new for $794, I'll let it go for $600 shipped in the CONUS.
I also have a FC2.1 that has been flown in the same Cinestar 8 with no problems or crashes or hard landings. This has not had the ACC upgrade done to it. It has a PPM sum cable installed and a telemetry line for the Graupner HOTT system. Bought new for $460, I'll let it go for $275 shipped in the CONUS.
And I also have a spare FC2.1 that I used on the 3 axis gimbal for stabilization and control it has a Futaba S.Bus signal inverter on it. This has not had the ACC upgrade done to it. Bought new for $460, I'll let it go for $275 shipped in the CONUS.
Again all of the above electronics have been used in a Cinestar 8 and have never been crashed or run hard. I purchased everything from Quadrocopter in MT on 7.24.12 and flew the first time on 8.8.12. They all have relatively low flight time(less than 20 hours). I have had no problems with these components at all. Just clearing some gear for some heavy lift conversion bits. Reasonable offers will be considered I am not interested in trading for anything. Thank you for you time!
View attachment 15054View attachment 15055View attachment 15056
I also have a FC2.1 that has been flown in the same Cinestar 8 with no problems or crashes or hard landings. This has not had the ACC upgrade done to it. It has a PPM sum cable installed and a telemetry line for the Graupner HOTT system. Bought new for $460, I'll let it go for $275 shipped in the CONUS.
And I also have a spare FC2.1 that I used on the 3 axis gimbal for stabilization and control it has a Futaba S.Bus signal inverter on it. This has not had the ACC upgrade done to it. Bought new for $460, I'll let it go for $275 shipped in the CONUS.
Again all of the above electronics have been used in a Cinestar 8 and have never been crashed or run hard. I purchased everything from Quadrocopter in MT on 7.24.12 and flew the first time on 8.8.12. They all have relatively low flight time(less than 20 hours). I have had no problems with these components at all. Just clearing some gear for some heavy lift conversion bits. Reasonable offers will be considered I am not interested in trading for anything. Thank you for you time!
View attachment 15054View attachment 15055View attachment 15056
Attachments
Last edited by a moderator:
