I got a tiny flight controller!

Hoki

Hoki

Member
Ohhhh it finally came in the mail! Now I can finish this little tarot 250. But it wont fit where I wanted it to fit! I guess I'll have to stick it on the bottom and I think I'll drill a little hole to feed the wires up so all the wires will be between the bottom and top plate so it won't look messy.
[url=http://postimg.org/image/5c1sp7obn/] [/URL]
[url=http://postimg.org/image/uww9h0925/] [/URL]
[url=http://postimg.org/image/4kg5g52f3/] [/URL]
[url=http://postimg.org/image/wqlir4m3n/] [/URL]
[url=http://postimg.org/image/qg3wibuu5/] [/URL]
 

Alwil

Alwil

Member
Hoki- Can you put some short standoffs between the plates and give yourself
a little more room to put in the flight controller? It looks like all you need is 1/4 inch.
That would be better than having the controller underneath where it could be damaged.
 

Hoki

Hoki

Member
where do I find such small spacers and I think if I did that I'd need all my screws to be longer too. that seems like more work than I wanna do. I don't like it on the bottom cause I was thinking like wet grass and crap will be touching it but maybe I'll just like making a little cover or enclosure for it. Cause there is kind of a lot of wires and it would be nice to use all the area to hide the wiring for a clean look.
 



Hoki

Hoki

Member
OK so I installed the motors last night and set up clean flight and omg there's some weird problems. When I plug in my battery the motors twitch a looot while making little sounds like there tiny gerbals talking to each other and it goes on for a long @ss time. Ive calibrated them in clean flight haven't done them one by one yet but they still r doing it. I've been learning different escs behave different and I am not familiar with these tiny tarot escs but from what I've read they r not configurable. I can arm it fine and if I arm it they spot talking but then I had a hard time cause one motor wouldn't turn and when I went in clean flight I noticed I would have to bring up the bar almost all the way to get the one motor to spin. So this one motor isn't really being in sync. There was a time when I thought I had it fixed cause I'd move the master control bar up and they all would go together but when I use the remote they arnt. Maybe I should try base flight with Lil ****. I do have some long @as wires going from the escs to the motors that I bunched up and ziptied. I wonder if that has something to do with it
 

You must log in or register to reply here.
Top