Photronix
Pilot
The new HoverflyGIMBAL 3-axis gimbal controller IS NOW SHIPPING.
Our gimbal controller will work with any servo controlled gimbal and is independent of the flight controller (of course we think you should use Hoverfly but.....). The tiny controller uses 8 microcontrollers, 3-axis Gyro, 3-axis Accel, and 3-axis magnetometer to provide fast and reliable gimbal stabilization. Basic modes provide the user with the ability to autocompensate while also providing manual control from your flight transmitter or a second transmitter. More advanced modes will allow the user to pre-program shows (set motion patterns) that can be activated with a switch on the transmitter. Magetic heading hold is also available with pan capable gimbals. In addition, the HoverflyGIMBAL will work without a tx/rx for auto-compensation while you fly.
Here is an introduction video....
....and here is an in-flight video.
For more information and to order one go to our website---->http://www.hoverflytech.com/gimbal_1WNK.html
Our gimbal controller will work with any servo controlled gimbal and is independent of the flight controller (of course we think you should use Hoverfly but.....). The tiny controller uses 8 microcontrollers, 3-axis Gyro, 3-axis Accel, and 3-axis magnetometer to provide fast and reliable gimbal stabilization. Basic modes provide the user with the ability to autocompensate while also providing manual control from your flight transmitter or a second transmitter. More advanced modes will allow the user to pre-program shows (set motion patterns) that can be activated with a switch on the transmitter. Magetic heading hold is also available with pan capable gimbals. In addition, the HoverflyGIMBAL will work without a tx/rx for auto-compensation while you fly.
Here is an introduction video....
....and here is an in-flight video.
For more information and to order one go to our website---->http://www.hoverflytech.com/gimbal_1WNK.html
Last edited by a moderator: